A Guide to Energy Saving in Office and Other Commercial Spaces

As you probably know, office and industrial buildings consume a significant amount of energy. Almost a third of these indicators go to lighting and therefore, light should be considered with maximum emphasis on energy efficiency. If you take into account this important factor, you can save on electricity, which will benefit not only the budget, but also the environment. A few simple lighting upgrades is one small investment an office can make to save energy.

one. Top lighting

If your office or factory is still using old fluorescent lighting or large overhead lights, it might be time for an upgrade. Although fluorescent lamps consume less energy than incandescent lamps, they are still no match for LED lamps. LED lighting uses approximately 75-80 percent less energy than fluorescent lamps and at the same time lasts longer without the need for replacement. Large fluorescent fixtures can be swapped out for LED panels that will work just as well and use less energy. An example of such lamps is the products of the company “Darion” . On the site), various LED lamps are presented: ceiling, industrial, recessed, street and much more.

If your lighting is provided by T12 fluorescent lamps, then even upgrading to T8 will make a big difference in energy savings and light quality. However, if you want to make an even bigger impact on your electricity consumption, go for 18 watt T8 LED bulbs instead of 32 watt T8 fluorescent bulbs. These lamps also do not produce any body, which means you will spend less money on the air conditioner, which will try to balance the temperature.

2. accent lighting

Accent lighting is used to highlight the company logo. It can also be presented as a wall lamp, which highlights the decor of the wall and adds to the interior appeal. In any case, if you use this type of lighting, which is usually used only for accents and decor, switch to LED technology with minimal electricity consumption.

3. Modern look

Since many people stay in close proximity to their workplace or inside a department for most of the day, some parts of the building and office space do not require constant lighting, such as toilets, break rooms, kitchens, etc. P. Installing motion sensors in these areas is a convenient way to control the amount of light used. If you are lucky enough to have your own office where you have access to the mains, install dimmers that will control the light level at any given time.

four. Emergency lighting

Buildings require the installation of emergency signs and exit signs. These signs use energy 24 hours a day, 7 days a week, so you should look for devices that will use less electricity. LED signs can last up to 25 years, and photoluminescent exit signs are considered even more energy efficient. They do not require electricity at all, but they are charged and powered by external light sources.

Leave a comment

Leave a Reply

Your email address will not be published.